Custom Functions - Minolta DYNAX 9 Ti Mode D'emploi

CUSTOM FUNCTIONS

Cust 6 — Focus Hold Button (Lens)
The mounted lens must have a focus hold button.
1 – Focus Hold
Pressing the focus-hold button on the lens locks
the focus.
2 – Spot Focus
Pressing the focus-hold button on the lens
selects the center focus sensor.
3 – Continuous Focus
Select this setting when focusing on moving
subjects.
Pressing the focus-hold button on the lens
selects continuous focus.
Cust 7 — Eyepiece Sensor
1 – Grip sensor activated
Eyepiece sensor is activated when the grip sensor is tripped.
2 – Main switch activated
Eyepiece sensor is activated when the main switch is in the ON position. Use this
setting when the grip sensor is not being tripped (user wearing gloves).
• Slide the main switch to LOCK when the camera is not being used.
10
Cust 8 — Frame Counter
1 – Frame counter in data panel counts up.
2 – Frame counter in data panel counts down.
• The frame counter counts up when non-DX coded film is loaded.
Cust 9 — AF Button
1 – Selectable focus area
Press the AF button and turn the control dial to
specify the desired local focus area.
2 – Spot Focus
Press the AF button to focus using the center focus
sensor.
Cust 10 — AE-Lock Button
• AEL appears in the viewfinder when AE-lock button is active (down).
• Slow sync is selected when the built-in flash is up or an attached accessory flash is on.
• Manual shift is selected when the exposure mode is set to manual.
1 – Press to activate, release to cancel.
2 – Press once to activate, press again to
cancel.
• Turning the built-in flash on or off cancels AE lock.
11