Publicité
Les langues disponibles
Les langues disponibles
CUSTOM FUNCTIONS
Mid Reload
Mid Reload decreases the chances of accidental double exposure when reloading a
partially exposed roll of film.
• Reloading a partially exposed roll increases the risk of film damage (scratches) caused by
dust and grit.
1. Set custom function 3 to setting 3 .
2. Load the film.
• The film is automatically advanced to frame 1.
3. Open the control panel door, then
4. Turn either control dial until the
• Advance the film a minimum of two frames past
5. Press the adjust button.
• The film is automatically advanced to the desired
8
press and hold the adjust button
until 1 blinks in the data panel.
frame number you want to advance
the film to blinks in the data panel.
the last exposed frame.
frame.
Cust 4 — DX Memory
1 – DX Memory Off
Film speed is always set to the DX-coded ISO. Non-DX-coded film is set to the
previous roll's ISO.
2 – DX Memory On
Changes to the film speed for a DX coded roll are saved and applied to future rolls
with the same DX coded ISO. Use to consistently over/under-expose a specific film
type.
• Film must be loaded before the ISO can be changed.
Cust 5 — Release Lock (Film)
1 – Release Lock Off
2 – Release Lock On
Shutter cannot be released unless film is loaded or the back cover is open.
•
blinks in the frame counter if the shutter-release button is pressed when film is not
loaded.
9
Publicité
