Publicité
Page | 8
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, start by removing the cover on top of the chain guard to gain access to the licence plate
illuminator connector. To do this, remove the push rivet and bolt at the front, as arrowed in picture 1, and then
slide the cover forward to unclip it from the chain guard and expose the wiring connector, as shown in picture 2.
•
Remove the four bolts that secure the OEM plastic cover in place, as arrowed in pictures 3 & 4 and rest the cover
on top of the rear wheel, as the wiring will remain connected.
•
Remove the three bolts that mount the sheet metal bracket in place, as shown in pictures 5 & 6.
•
Remove the two bolts on the back of the wrap around metal bracket using a spanner, as shown in picture 7.
There is enough room to remove the bolt with the tyre/wheel in place.
•
Remove the cable tie securing the wiring, as shown in picture 8.
•
Remove the two bolts that hold the plastic cover in place on the rear of the mounting arm and pull the cover
clear to allow the licence plate illuminator wiring to be removed from the bike, as arrowed in picture 9. The
OEM licence plate bracket can now be removed from the rear tyre.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 31
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Picture 33
R&G Racing
www.rg-racing.com
Email:
Picture 32
info@rg-racing.com
Publicité
