Publicité
•
Take two of the indicator adaptors (item 15 – I0036) and position over the mini indicator wiring, ensuring the
raised bosses on the adaptors plates face each other.
•
Feed the wiring through the mounting hole in the plastic mount and position one adaptor on either side of the
plastic mount, before fitting the nut and tightening to clamp the adaptors securely in place, as shown in picture
32.
•
Route the mini indicator wiring up through the existing hole into the tail unit and connect bullet connectors from
Page | 10
one of the mini indicator connectors (item 16 – CON0027). Connect this connector to the OEM connector on the
main loom, with the grey connector fitting to the left side indicator.
•
Repeat the same procedure to fit the remaining indicator.
•
Test for the correct operation of the indicators at this stage. If illumination fails on any light, re-connect the
bullet connectors the other way around.
•
Re-fit the plastic covers the indicator housing along with the Phillips screw, as shown in picture 33.
•
Re-fit the pillion seat.
•
Ensure the tail tidy is securely mounted and all bolts are fully tightened.
•
Test the licence plate illuminator and all lights before riding.
Digital copies of these instructions are available to download from
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G
shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident
or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for
indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service
concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 20/07/2017 (HH)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com
Email:
www.rg-racing.com
info@rg-racing.com
Publicité
