Dometic Midi Heki Style 700 x 500 Instructions De Montage Et De Service page 8

Installing the Midi Heki Style
➤ Place the outer frame in the middle of the roof opening.
➤ Press the outer frame in the roof slightly so that the packing compound spreads
out.
fig. 9
See
➤ Place the 11 mounting supports on the inside of the vehicle all the way into the
recess of the outer frame.
If you use wooden rails as reinforcement
A
NOTICE!
Do not drill through the roof construction.
➤ Pre-drill two 2.2 mm holes for each mounting support in the roof
construction (A).
➤ Fix the mounting supports on the roof with the ∅ 3.5 mm screws included (B).
For other constructions, suitable screws must be used (not in scope of delivery).
➤ Fix the 11 mounting supports with the ∅ 4 mm fixing screws to the outer
frame (C).
To do this use the large holes in the mounting supports.
Making a final check
➤ Check visually whether the seal all round the outer frame is against the roof
surface and the mounting supports are aligned.
➤ Tighten the screws about 10 minutes after installation.
fig. 0
See
A
NOTICE!
Geared version: Hold the hand crank in the closed position when
placing the inner frame on the outer frame, otherwise the position of the
hand crank (2) will be misaligned with the hexagon part (3).
➤ Press the inner frame into the groove (1) on the mounting supports.
8
Midi Heki Style 700 x 500
EN