Setting The Timer For Energy-Saving Stand-By Mode - Function Setting 2 - Melitta CAFFEO Guide D'utilisation

Water hardness
range
• Press the on/off button
gory.
→
Depending on the selection 1 to 4 bean symbols
display. The appliance is in stand-by mode again.
Setting the timer for energy-saving stand-by mode
– function setting 2
Additional information on energy-saving stand-by mode is provided on page 58.
The timer is factory-set to level 2 (15 minutes).
Please adjust the timer as follows:
Prerequisite: The appliance must be in stand-by mode.
→ The on/off button
•
Simultaneously press the button for single-cup dispensing
ton for steam dispensing
• Press the button several times for brewing strength
possible times for the timer.
→
The button for brewing strength
→
Your selection is indicated by the bean symbols
Properties
soft 0 - 7,2 °dH
medium 7,2 - 14 °dH
hard 14 - 21,2 °dH
very hard > 21,2 °dH
to confirm the selected water hardness cate-
will be illuminated red.
, until the four buttons are faintly illuminated.
is brightly illuminated.
°dH °f
0 - 13 °f
13 - 25 °f
25 - 38 °f
> 38 °f
will be flashing in the
and the but-
to select from four
in the display.
59