Setting The Timer For Energy-Saving Standby Mode - Melitta SOLO Mode D'emploi

•
Press the On / Off button
hardness.
→ All symbols in the display flash briefly for confirmation. The appliance is
ready for operation, the standby symbol
Note
During the adjusting process, if you do not press a button within 60 se-
conds the appliance automatically reverts to standby mode.
Setting the timer for energy­saving standby mode
Additional information on energy-saving standby mode is provided on page 52. the
timer is factory-set to level 1 (15 minutes).
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
Adjust the timer as follows:
• simultaneously press the button for single-cup dispensing
button for two-cup dispensing
→
the standby symbol
•
Press the button for single-cup dispensing
adjusting water hardness.
→ the symbol for the water reservoir
•
Press the brewing strength button several times
possible times for the timer.

Heft_Solo_EU.indd 54
to confirm the selected degree of water
is illuminated.
for more than 2 seconds.
is flashing rapidly.
twice to call the menu for
is illuminated.
and the
to select from four
09.07.2009 15:47:36