Cleaning The Brewing Unit - Melitta CAFFEO Guide D'utilisation

Cleaning the brewing unit

Prerequisite: The appliance must be in stand-by mode.
•
Switch the power switch (Fig. B, no. 20) into position "0" to completely
switch off the appliance.
•
Reach into the recess on the right side of the appliance (Fig. B, no. 18) and
pull off the cover to the right.
•
Activate the red button on the handle of the brewing unit (Fig. H) and
turn the handle in the direction of the arrow to the stop (approximately
75°).
•
Use the handle to pull the brewing unit out of the appliance.
•
Leave the brewing unit as it is (do not move or twist the components of
the brewing unit).
•
Thoroughly rinse off the brewing unit as a whole from all sides under
running water. Particularly ensure that the surface shown in Fig. J is free
of coffee residue.
•
Let the brewing unit drip dry.
• If necessary, remove coffee residues from the surfaces in the interior of
the appliance where the brewing unit is inserted.
• Put the brewing unit back into the appliance.
•
Activate the red button on the handle of the brewing unit and turn the
handle clockwise to the stop (approximately 75°). In this process ensure
that the handle locks in place.
• Insert the two catches of the cover in the back of the appliance and swing
the cover to the left until it engages.
• Switch the power switch (Fig. B, no. 20) to the "I" position.
→
The appliance is in stand-by mode again.
Note
For optimal protection of your appliance, we recommend that you clean
the brewing unit once a week.
64