Rear Panel Description - Sony MDS-JB940 Mode D'emploi

• "OPT2" lights when the program source is
connected to the DIGITAL OPTICAL IN2
connector.
• "COAX" lights when the program source is
connected to the DIGITAL COAXIAL IN jack.
• "ANALOG" lights when the program source is
connected to the ANALOG IN jacks.
F Music calender
Shows all the track numbers within a grid if the MD is
a premastered disc, or without a grid if the MD is a
recordable disc. If the total number of tracks exceeds
15, B appears to the right of number 15 in the music
calendar.
G SLEEP indicator (41)
Lights when the deck is set to turn off automatically
after specified minutes.
H Level meters
Display the audio signal levels during playing and
recording.
Note
The display format that you have selected in each of the deck
statuses (play, recording, etc.) will appear whenever the deck
enters that status and you press DISPLAY/CHAR (or DISPLAY)
or TIME until you change the format to another (see the
following sections for details). If you disconnect the AC power
cord, however, all the displays will revert to their default (i.e., the
factory set display) the next time you turn on the deck.
To change the display in stop mode
Press DISPLAY/CHAR (or DISPLAY) repeatedly to
change the display.
Each press of the button changes the display as follows:
Total number of tracks, total recorded time and
1)
disc name
r
The contents of a program (only when "PGM"
lights up)
r
Level of the input signal (setting value of the
recording level)
r
Pitch display
r
DF (digital filter) display
1) "No Name" appears when the disc has no name.

Rear panel description

C O I O I C C O I
I I 2 I 1
A ANALOG IN jacks (11) (14)
Use to input analog signals from other components.
B ANALOG OUT jacks (11)
Use to output analog signals to other components.
C CONTROL A1ΙΙ jacks (11) (44)
D DIGITAL COAXIAL IN jack (11) (14)
Connect a digital coaxial cable to input digital signals
from other components.
E DIGITAL OPTICAL IN connectors (11) (14)
Connect a digital optical cable to input digital signals
from other components. There is no distinction of IN1
and IN2 connectors.
F DIGITAL COAXIAL OUT jack (11)
Connect a digital coaxial cable to output digital signals
to other components.
G DIGITAL OPTICAL OUT connector (11)
Connect a digital optical cable to output digital signals
to other components.
Display window description/Rear panel description
O I C
O O
9
GB