Recording Tips - Sony MDS-JB940 Mode D'emploi

Note
The volume can only be increased up to +12.0 dB (for analog
recording) or +18.0 dB (for digital recording). Therefore, if the
output level of the connected component is low, it may not be
possible to set the recording level to maximum.
18
GB
Adjusting the recording level/Recording tips

Recording tips

TIME
Checking the remaining recordable time
on the MD
Press TIME repeatedly.
The following information
While the deck is
appears
Total number of tracks and total
recorded time y Total number of
Stopped
tracks and remaining recordable time on
the MD
Track number and recorded time of the
current track y Track number and
Recording
remaining recordable time
1) Not shown for premasterd discs.
2) Time shown in the display differs depending on the setting of
REC MODE.
Monitoring the input signal
(Input Monitor)
You can monitor the selected input signal even when you
are not recording it.
1 Press EJECT A to eject the MD.
2
Press INPUT repeatedly to select the jacks
(connector) where the signal you want to monitor
is being input.
3 Press REC z.
When INPUT is set to ANALOG
The analog signal input from the ANALOG IN jacks is
output to the DIGITAL OUT connector after A/D
conversion, and then to the ANALOG OUT jacks and
PHONES jack after D/A conversion. "AD – DA"
appears in the display during this time.
When INPUT is set to OPT1, OPT2 or COAX
The digital signal input from the DIGITAL IN
connector is output to the DIGITAL OUT connector
after passing through the sampling rate converter, and
then to the ANALOG OUT jacks and PHONES jack
after D/A conversion. " – DA" appears in the display
during this time.
REC z
INPUT MENU/NO
EJECT A
AMS YES
1)
2)
on the MD