Locating A Particular Point In A Track - Sony MDS-JB940 Mode D'emploi

z
You can extend the playing time during Music Scan
1 While the deck is stopped, press MENU/NO twice.
"Setup Menu" appears in the display.
2 Turn AMS (or press ./> repeatedly) until "M.Scan"
appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select the
playing time within a range of six to twenty seconds (in
one second steps), then press AMS or YES.
4 Press MENU/NO.
Playing a track by entering the track
number Z
Press the number button(s) to enter the track number
of the track you want to play.
To enter a track number over 25
1
Press >25.
2
Enter the corresponding digits.
To enter 0, press 10 instead.
Examples:
• To play track number 30, press >25, then 3 and 10.
• To play track number 108, press >25 twice, then 1,
10, and 8.
z
If you enter a track number while the deck is paused
The deck will still be paused at the beginning of the track.
Locating a particular point
in a track
You can locate a particular point in a track during play or
play pause.
Locating a point while monitoring the
sound
During play, press down m/M until you reach the
point you want.
You will hear intermittent playing as the disc goes forward
or in reverse. When you reach the point you want, release
the button.
Notes
• If the MD reaches the end while you're pressing M, the deck
stops.
• Tracks that are only a few seconds long may be too short for
monitoring. For such tracks, play the MD at normal speed.
Locating a point by observing the time
indication
During play pause, press down m/M until you reach
the point you want.
When you reach the point you want, release the button. To
start playing, press H or X. No sound is output during
this time.
z
When "– Over –" appears in the display
The MD has reached the end while you're pressing M. Turn
AMS counterclockwise (or press .) or press m to go back.
Playing a specific track/Locating a particular point in a track
m/M
25
GB