Playing A Specific Track - Sony MDS-JB940 Mode D'emploi

Note
When you eject the MD or turn off the deck, the output level is
reset to the factory setting (0.0 dB).
To change the display during playing
Press DISPLAY/CHAR (or DISPLAY) repeatedly to
change the display.
Each press of the button changes the display as follows:
Track number and elapsed time of the current
track
r
The contents of a program (only when "PGM"
lights up)
r
Disc name and track name
r
Level of the output signal
r
Pitch display
r
DF (digital filter) display
z
You can check the remaining time
Press TIME during playback. Each press of the button changes
the display as follows:
Track number and elapsed time of the current
track
r
Track number and remaining time of the current
track
r
Remaining time of all recorded tracks
z
You can check the track name while playing
Press SCROLL.
The track name appears and scrolls. While the track name is
scrolling, press the button again to pause scrolling, and again to
continue scrolling.
24
GB
Playing an MD/Playing a specific track

Playing a specific track

While the deck is playing or stopped, use the procedure
below to quickly play any track.
Locating a track with AMS
To go to
The next or a succeeding track
during play
A preceding track during play
The beginning of the current
Z
track during play
A specific track while the
deck is stopped
A specific track by scanning
each track for six to twenty
seconds (Music Scan) Z
1) Automatic Music Sensor
z
You can locate the last track of the MD quickly
While the deck is stopped, turn AMS counterclockwise (or press
. once).
z
If you locate a track while the deck is stopped or
paused
The deck will still be stopped or paused at the beginning of the
located track.
Number buttons
>
25
M.SCAN
./>
H
AMS
1)
Do the following:
Turn AMS clockwise (or press
> repeatedly).
Turn AMS counterclockwise
(or press . repeatedly).
Turn AMS counterclockwise
(or press . once).
Turn AMS (or press ./
> repeatedly) until the track
number you want to go to
flashes in the display, then
press AMS or H.
Press M.SCAN before you
start playing. When you find
the track you want, press H
to start playing.
` / 1
Z
H X x
. > z
m M
X . >