Use - SATA HRS Mode D'emploi

■ In the event of damage, immediately discontinue use of the pressure
spray gun and disconnect it from the compressed air circuit.
■ Observe safety precautions.
Cleaning media for cleaning the pressure spray gun
■ Never clean the pressure spray gun with cleaning media that contain
acids or lye.
■ Never use halogenated hydrocarbon based cleaning media.
■ Contact the cleaning media manufacturer to clarify which chemicals are
used in the cleaning media.
Cleaning agents and preservatives
■ When using cleaning media, such as cleaners for vehicle exhaust sys-
tems, use only the variant with the plastic pressure cup.
■ Aluminum pressure cups are recommended when using preservatives,
such as wax or underbody sealant.
Connected components
■ Use only genuine SATA replacement parts or accessories.
■ The connected hoses and lines must reliably withstand the expected
thermal, chemical and mechanical load requirements when operating
the pressure spray gun.
■ Disconnecting pressurized hoses can cause them to move in a whip-
like manner, resulting in injuries. Always bleed the hoses completely
before removal.
Operating site
■ Never use the pressure spray gun in areas near ignition sources, such
as open flames, burning cigarettes or electrical equipment that is not
explosion proof.
General
■ Never point the pressure spray gun at animals (including humans).
■ Comply with local regulations concerning safety, accident prevention,
occupational safety and environmental protection.
■ Observe accident prevention regulations BGR 500.

3. Use

Intended Use
The pressure spray gun is intended for applying cleaning and preserva-
tive media on surfaces and in cavities.
Improper use
The pressure spray gun is not intended to be used for the application of
Operating Instructions for SATA HRS
US
473