Description; Scope Of Delivery; Technical Design; Technical Data - SATA HRS Mode D'emploi

Operating Instructions for SATA HRS
US
paints and coatings.

4. Description

This pressure spray gun is connected to the compressed air circuit using
a quick connect nipple and air hose. Operating the trigger introduces
the compressed air into the pressure cup via a check valve. The excess
pressure conveys the material to the mixing cap via the suction pipe. The
spray air and material are mixed in the mixing cap via another air pas-
sage. The air/material mixture is conveyed to the wand tip via the quick
connect coupling and atomized to a fine mist depending on the wand tip
used.

5. Scope of Delivery

■ Pressure spray gun, depending on whether equipped with / without
material flow control
■ Pressure spray gun, depending on model
■ Various wand systems, depending on model

6. Technical Design

Pressure spray gun
HRS-E variant
[1-1]
Screw-on flange for HRS-E
[1-2]
pressure cup
[1-3] Suction pipe for HRS-E
Pressure cup for HRS-E
[1-4]
Pressure cup adapter
[1-5]
Suction pipe
[1-6]
Pressure cup, plastic
[1-7]
[1-8] Base ring
[1-9] Spray gun body
[1-10] Paint needle

7. Technical Data

Description
Average spraying pressure
Max. spraying pressure
Max. temperature of coating material
474
[1-11] Trigger
[1-12] Air connection
[1-13] Pressure cup, aluminum
[1-14] Suction pipe
[1-15] Quick connect coupling
[1-16] Mixing cap
[1-17] Safety valve
[1-18] Check valve
[1-19] Guide bushing
[1-20] Counter nut
[1-21] Material flow control nut
Variation
with plas-
tic pressure
cup
58 psi – 87
psi
87 psi
122 °F
Variation
with alumi-
num pres-
sure cup
58 psi – 116
psi
145 psi
176 °F