Use - SATA HRS Mode D'emploi

components are missing.
■ Always replace plastic pressurized caps after 2 years of use.
■ When damaged, stop using the pressurized cup spray gun immediately
and disconnect it from the compressed air circuit.
■ Adhere to safety regulations.
Cleaning agents for cleaning the pressurized cup spray gun
■ Never use acidic or alkaline cleaning agents to clean the pressurized
cup spray gun.
■ Never use cleaning agents based on halogenated hydrocarbons.
■ Check the cleaning agents with the manufacturer of the chemicals that
you are using.
Processing agents
■ When processing cleaning agents such as cleaners for vehicle exhaust
systems, only use the version with plastic pressurized cup.
■ When processing preservatives, such as wax or underbody protection,
give preference to the version with aluminium pressurized cup.
Connected components
■ Only use original SATA spare parts and accessories.
■ The connected hoses and lines must reliably withstand the thermal,
chemical and mechanical loads expected when using the pressurized
cup spray gun.
■ When pressurized hoses work loose, their whip-like movements can
cause injuries. Always vent the hoses completely before they are loos-
ened.
Point of use
■ Never use the pressurized cup spray gun in the vicinity of ignition sourc-
es, such as naked flames, burning cigarettes or non-explosion-proof
electrical equipment.
General
■ Never point the pressurized cup spray gun at human beings.
■ Comply with the local regulations for safety, accident prevention, occu-
pational health and safety and environmental protection.
■ Adhere to BGR 500 accident prevention regulations.

3. Use

Intended Use
The pressurized cup spray gun is intended for applying cleaning agents
and preservatives onto surfaces or into cavities using wand systems.
Operating Instructions SATA HRS
EN
115