Design Of The Paint Pressure Tank; Intended Use; General Safety Instructions - SATA paint set 10 Mode D'emploi

Operating instructions SATA paint set 10, SATA FDG 24, SATA FDG 48
All manuals and user guides at all-guides.com

4. Design of the Paint Pressure Tank [1]

[1-1] Paint pressure tank
[1-2] Control knob for atomisation
pressure regulation
[1-3] Ventilation valve
[1-4] Material connection
[1-5] Material shut-off valve
[1-6] Control knob for material
pressure regulation
[1-7] Safety valve
[1-8] Pressure gauge for internal
tank pressure
[1-9] Pressure gauge for atomisa-
tion air (optional)
[1-10] Main air tap
[1-11] Air connection
[1-12] FDG 48 with double pres-
sure reducer
[1-13] Lid for filler neck

5. Intended Use

The SATA paint pressure tank has been designed for the application of
sprayable media (paints/other materials) by means of compressed air.
6. Safety Instructions

6.1. General Safety Instructions

• Before using the paint pressure tank, please read all safety and the
operating instructions carefully. Safety instructions and indicated
safety measures are mandatory.
• Please keep all enclosed documents and make sure that the paint
pressure tank is handed over only together with these documents.
[1-14] Clamping yoke with toggle
[1-15] Air connection for the spray
[1-16] Container lid
[1-17] Hand agitator
[1-18] FDG with pneumatic agitator
[1-19] Air micrometer (air flow
[1-20] Sound absorber
[1-21] FDG with pneumatic agitator
[1-22] FDG with motor
[1-23] FDG with outlet at bottom
[1-24] SATA paint set 10 single
Warning! Attention!
screw
gun
without gear drive
control knob)
with gear drive
pressure reducer with carry-
ing handle
EN
23