Intermediate Position - Becker Centronic VarioControl VC320 Notice De Montage Et D'utilisation

▻ The sun protection shifts to confirm.
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The sun protection shifts to confirm.
► The new transmitter has now been programmed.
The intermediate position is any roller shutter position of
your choosing, situated between the upper and lower end
position. Both limit positions must be set before the interme-
diate position is set.
The curtain runs to the intermediate position from the upper
limit position.
Setting the intermediate position
Move the shading solution from the upper limit position to the desired interme-
diate position.
Press the STOP button and, within 3 seconds, also press the DOWN button
and hold the two buttons down.
▻ The sun protection shifts to confirm.
► The intermediate position is now saved.
Checking the intermediate position
Press the DOWN button twice within one second.
► The shading solution runs to the intermediate position.
24 - en

Intermediate position