Explanations; Intermediate Position; Roller Shutter Or Venetian Blind Setting - Becker Centronic MemoControl MC42 Notice De Montage Et D'utilisation

Assembly and Operating Instructions

Explanations

Manual/Automatic sliding switch
When the sliding switch is switched to , only manual control commands are
carried out (e.g. by pressing the UP, STOP and DOWN buttons).
When the sliding switch is switched to , automatic control commands are car-
ried out (e.g. switching time).
Control light
Acknowledges that the switching times have been set by flashing 3 times.
Selecting roller shutter or venetian blind
Either the roller shutter or venetian blind mode can be set using the encoding
switch on the back of the device.
When the roller shutter function is used, the roller shutter remains locked after a
control button has been activated.
RESET button
When the RESET button is pressed (with a ballpoint pen or similar), all switching
times, intermediate position and ventilation/reverse position are deleted.

Intermediate position

The intermediate position is a position of the roller shutter/venetian blind be-
tween the upper and lower limits and can be freely selected. This position can
also be reached from the upper position after programming.
Press the DOWN button twice in rapid succession to move to the intermediate
position.
Ventilation/Reverse
The ventilation/reverse position is a position of the roller shutter/venetian blind
between the upper and lower limits and can be freely selected. Using this func-
tion, you can raise the shutter from the lower end limit until the ventilation slits
are open. In the case of venetian blinds, the slats will be opened.
Press the UP button twice in rapid succession to move to the ventilation/re-
verse position.
Roller shutter or venetian blind setting
The roller shutter or venetian blind mode can be selected accordingly using the
encoding switch on the back of the device.
16