Drawings - MORIA Epi-K 65043 Manuel Utilisateur

11 DRAWINGS

A. DISPOSABLE HEAD
1 Threaded shaft
2 ONE EPI
3 Separator housing
4 Slide
5 Separator
6 Aplanating plate
B. SUCTION RING
1 Vacuum connection
2 Stop setting screw
3 Stop
4 Guiding
5 Ring size
6 Threaded shaft
C. SETTING THE STOPPER
1 Loosen safety screw
2 Turn stop to desired value (the desired stop
value must face the ring). Tighten screw with
fingers
D. CONNECTING THE SUCTION RING TO THE
ASPIRATION TUBING
1 Aspiration tubing end
2 Suction ring end
E. MOTOR
1 Motor housing
2 Motor cord
3 Threaded ring
4 Oscillation motor shaft
5 Head alignment guide
6 Advance drive
F. MOUNTING THE HEAD ON THE MOTOR
1 Screw the head clockwise onto the threaded
motor shaft.
2 Check that the head is screwed on tightly to
the motor.
3 There should be no rotation of the head.
G. MOUNTING THE HEAD ON THE SUCTION
RING
1 When inserting the head in the rails of the
suction ring, the handpiece must be at a 45°
angle from the threaded shaft of the ring
2 Once the head properly inserted, slightly
reduce the angle from 45° to 0°
H. ALIGNMENT OF THE HEAD, MOTOR AND
SUCTION RING
1 Alignment of the threaded shaft with the
motor
I. CLEANING THE MOTOR
1 Disposable brush (#19149)
2 Maximum submersion
3 Sterile distilled water
#65043-H-02.2017
13
MORIA