Hazard: Hazardous Vapors - Titan THERMOMARK 300 Série Mode D'emploi

THERMOMARK

HAZARD: HAZARDOUS VAPORS

Toxic vapors or fumes are harmful if inhaled or
come in contact with the body. Vapors can cause
severe nausea, fainting, or poisoning.
PREVENTION:
•
Appropriate protective equipment must be worn when
operating, servicing or when in the operating area of the
equipment. Equipment includes but not limited to:
- Protective clothing and respirator as recommended by
the fluid, material and solvent manufacturer.
- Protective gloves, shoes, overalls, face shield and hat
rated for elevated temperatures of at least 500ºF (260ºC).
•
Wear respiratory protection when using the equipment.
Read all instructions supplied with the mask to be sure it
will provide the necessary protection.
•
All local regulations regarding protection against
hazardous vapors must be observed.
•
Read SDS to know the specific hazards of the materials you
are using.
HAZARD: BURN HAZARD
Certain components of the equipment are heated
and become hot during operation.
PREVENTION:
•
Do not touch heated material or equipment.
•
Allow material and equipment to cool before coming into
contact.
•
Appropriate protective equipment must be worn when
operating, servicing or when in the operating area of the
equipment. Equipment includes but not limited to:
- Protective clothing and respirator as recommended by
the fluid, material and solvent manufacturer.
- Protective gloves, shoes, overalls, face shield and hat
rated for elevated temperatures of at least 500ºF (260ºC).
HAZARD: GENERAL
This product can cause severe injury or property
damage.
PREVENTION:
•
Do not leave equipment unattended.
•
Do not leave equipment on an uneven surface as it can
fall over or roll away. Make sure the brake is activated
whenever not in use.
•
Keep childen and animals away from the equipment and
work area.
•
Do not exceed the maximum working temperature of
the lowest-rated system component (refer to Technical
Specifications).
•
Check equipment before every use. Immediately repair or
replace any worn or damaged parts.
- Use only manufacturer authorized parts. User assumes
all risks and liabilities when using parts that do not meet
the minimum specifications and safety devices of the
manufacturer.
•
Do not alter or modify the equipment. Any attempt
to modify the equipment or using non-authorized
replacement parts can lead to injury, damage the
equipment and will void the warranty.
•
Use the equipment for its intended purpose only. Contact
Titan distributor for more information.
•
Do not fill material container beyond maximum capacity.
•
Route gas lines, hoses, wires and cables away from sharp
edges, traffic areas, moving parts and hot surfaces.
•
Do not over-bend or kink gas lines.
•
Do not remove or override any safety devices.
•
Clean up all material and solvent spills immediately to
prevent slip hazard.
•
Do not operate the unit when fatigued or under the
influence of drugs or alcohol.
•
Keep a fire extinguisher in work area.
SAFETY PRECAUTIONS
5