Safety Precautions; Hazard: Injection Injury - Titan RX-80 Mode D'emploi

SAFEty PREcAutIoNS

Be safety-conscious! All local and national regulations governing
ventilation, fire prevention, and operation must be observed.

HAZARD: INjEctIoN INjuRy

A high pressure stream produced by this equipment can pierce the
skin and underlying tissues, leading to serious injury and possible
amputation. See a physician immediately.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT! Injection
can lead to amputation. See a physician immediately. Inform the
physician of the type of coating material or cleaning agent with
which the injury was caused.
The maximum operating range of the spray gun is 25 MPa / 3600 PSI
fluid pressure.
• NEVER aim the gun at any part of the body.
• NEVER allow any part of the body to touch the fluid stream. DO NOT allow
body to touch a leak in the fluid hose.
• NEVER put hand in front of the gun. Gloves will not provide protection
against an injection injury.
• Never point the spray gun at anyone else.
• ALWAYS lock the gun trigger, shut the pump off, and release all pressure
before servicing, cleaning the tip or guard, changing tip, or leaving
unattended. Pressure will not be released by turning off the motor. The
PRIME/SPRAY valve must be turned to PRIME to relieve the pressure. Refer
to the Pressure Relief Pressure described in the pump manual.
• ALWAYS keep the tip guard in place while spraying. The tip guard provides
some protection but is mainly a warning device.
• ALWAYS remove the spray tip before flushing or cleaning the system.
• The paint hose can develop leaks from wear, kinking and abuse. A leak can
inject material into the skin. Inspect the hose before each use.
• NEVER use a spray gun without a trigger lock and trigger guard in place and
in good working order.
• All accessories must be rated at or above the maximum operating pressure
range of the airless sprayer. This includes spray tips, extensions, and hose.
HAZARD: ExplOsIOn HAZARD DuE tO IncOMpAtIBlE MAtERIAls
Will cause severe injury or property damage.
• Do not use materials containing bleach or chlorine.
• Do not use halogenated hydrocarbon solvents such as bleach, mildewcide,
methylene chloride and 1,1,1 - trichloroethane. They are not compatible
with aluminum.
2
GB
RX-80