Adjusting The Stability And The Maneuverability; Maintenance; Regular Maintenance - Vermeiren Eclips+ Mode D'emploi

standard
If an anti-tip device is installed, it replaces the addition of the tipping lever and can be used
accordingly.

3.12 Adjusting the stability and the maneuverability

WARNING:
L Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
WARNING:
L Risk of injury - Make sure that the axle adapters  of the rear
wheels on both sides are mounted in the same position.
WARNING:
L Risk of tipping over - Be aware that you change the stability of the
wheelchair.
For the Eclips+ 30° there shall be standard an anti-tipping device mounted on the wheelchair
when the axle adapter  is positioned to the front.
4

Maintenance

Lifetime of the wheelchair is influenced by its use, storage, regular maintenance, servicing
and cleaning.
4.1

Regular Maintenance

The maintenance activities to ensure a good condition for your Vermeiren wheelchair are
described below:
Before every ride
Check the tyres and make them clean. If necessary change the tire.

Check screw fastenings are secured.

Check the brakes and adjusted if necessary.

Check the wheelchair (cleanliness, cracks, damage on structural parts ... .)

and make it clean. If necessary change the coating.
1. Remove the screws Ⓑ.
2. Adjust the height of the tip cap to a
comfortable position.
Tip cap height
150 mm (5.91 in.)
(Standard)
165 mm (6.50 in.)
Table 5: Tip cap heights for wheelchair with
3. Tighten the screws properly .
The driving wheels are mounted in an axle adapter  at
the bottom of the back frame .
1. Loosen the fixing screws .
2. Turn the axle adapter  to the back until the axle
mounting is behind the back frame.
3. Tighten the screws properly .
4. Adjust the brakes.
Page 23
Eclips+, Eclips+ 30°
Tube tip cap Ⓐ Tube frame Ⓒ
Hole 1 and 3 Hole 1 and 3
Hole 1 and 3 Hole 2 and 4
seat height of 500 mm
2011-05
(Fig C)