Adjusting The Wheelchair To The User; Changing Pneumatic Tyres (If Applicable) - Vermeiren Eclips X2 Kids Manuel D'utilisation

EN
NL
4.4

Adjusting the wheelchair to the user

4.4.1 Adjusting the parking brakes
1. Install the wheels according to §2.8.
2. Disconnect
backwards.
3. Loosen the bolt (2) so the brake mechanism can
slide over the tube (3) of the side frame.
4. Pull the brake mechanism to the desired position.
5. Retighten the bolt (2).
6. Check working of the brakes.
7. If necessary, repeat the above steps until the brakes
are well adjusted.
4.4.2 Adjusting the footrest length
Adjust the length of the footrest as follows (3 positions possible on
outside tubes, steps of 35 mm ; 6 positions possible on inner tubes,
steps of 25 mm) :
1. Remove the screw (4).
2. Adjust the length of the footrest to a comfortable length.
3. Tighten the screw (4) properly.
4.5

Changing pneumatic tyres (if applicable)

CAUTION
 Make sure all air is released from the tyre, before removing it.
 Make sure that no body parts, the inner tube nor any other objects are pinched between tyre
and rim.
 Make sure all screws are firmly secured by hand before driving with the wheelchair.
 Make sure that the pressure is correct, see the pressure indication on the tyres.
 Inflate the tyre using inflating equipment which complies to regulations and with a pressure
indication in "bar".
 Only use replacement parts approved by Vermeiren.
To change the tyre or inner tube, proceed as follows:
1. Let all the air out of the inner tube.
2. Insert a tyre lever between de tyre and the rim.
3. Gently push the tyre lever downwards. This will pull the tyre over the edge of the rim.
4. Move the lever along the rim so the tyre pops out.
5. Carefully remove the tyre from the rim and remove the tube.
the brakes by pulling
Risk of injuries and damage
3
lever (1)
14
Eclips X2 Kids, Eclips X2 30° Kids
Installation and adjustment
2
4
2022-07
1