Flexible Seat - Vermeiren Eclips+ Mode D'emploi

Adjustment of the slope nuts Ⓒ from the steering wheels.
WARNING:
L Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
WARNING:
L Risk of injury - Make sure that the eccentric screw settings are
identical on both front-wheel adapters and, before using the wheelchair.
This figure illustrates the principle. The position of the screw thread is indicated by a number.
3.4

Flexible seat

WARNING:
L Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
The seat frame is available in one of three seat depths 420 mm, 440 mm, 460 mm (16.54 in.,
17.32 in. and 18.11 in.).
The standard seat depth of the cover is 420 mm (16.54 in.). To close the gap between the
back frame and the seat, fold the flap of the backrest under the seat ( Velcro fastening).
Changing the seat cover as follows:
1. Remove the screw at the front end of the seat frame.
2. Pull the locking pin Ⓒout.
3. Now the seat Ⓐ can be removed by pulling it gently forwards out the sleeve of tube
Ⓑ.
Do the reverse when you want to replace the seat.
A
Shows the frame when the seat is horizontal and the
adapter is perpendicular to the ground.
B Shows the frame when the seat is tilted slightly and the
adapter is not perpendicular.
Page 19
Eclips+, Eclips+ 30°
2011-05