Mounting The Rear Wheels; Unfolding The Wheelchair; Mounting Or Removing Of The Footrests; Operating The Brakes - Vermeiren Eclips+ Mode D'emploi

2.2

Mounting the rear wheels

2.3

Unfolding the wheelchair

CAUTION:
Risk of clamping – Keep fingers away from moving parts of the
L
wheelchair.
1. Position yourself behind the wheelchair.
2. Use the hand-grips to open the wheelchair as much as possible.
3. Position yourself at the front of the wheelchair.
4. Push both seating tubes down till they are fixed in their position.
5. For Eclips+ 30° mount the push pole to the right handle.
2.4

Mounting or removing of the footrests

2.5

Operating the brakes

WARNING:
The brakes are not used to slow down the wheelchair during
L
movements – Use the brake only to prevent the wheelchair from unintended
movements.
WARNING:
L Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
WARNING:
L The brakes are adjustable and can wear – Check the operation of the
brakes before each use.
1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button.
4. Check that the wheel is secured.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchair frame and mount the tube hood
into the frame.
2. Swing the footrest inwards till it clicks in
position.
3. Swing the foot plate downwards.
To take off the footrests:
1. Pull handle .

2. Swing the footrest to the outside of the
wheelchair till it comes loose from the guidance.
3. Pull the footrest from tube hood
Page 8
Eclips+, Eclips+ 30°
2011-05
 .

.
