Adjusting The Seat Height And Seat Angle; Rear Wheel - Vermeiren Eclips+ Mode D'emploi

3.3

Adjusting the seat height and seat angle

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
L
the appropriate tool.
WARNING:
L Risk of tipping over - When the driving wheels are adjusted, the
position of the wheels are altered.
The Vermeiren Eclips+ is adjustable in 4 seat heights and different seat angles by changing
the wheels position. The Vermeiren Eclips+ 30° are adjustable in 3 seat heights 470 - 530
mm (18.5 in. - 20.87 in.) and different seat angles by changing the wheels position. At each
height there is a different setting of the front and rear wheels.
The summary of the different seat heights by a standard seat angle 7° is tabulated below.
Seat height
430 mm (16.93 in.)
470 mm (18.50 in.)
500 mm (19.69 in.)
(Standard)
530 mm (20.87 in.)
Change the seat height and seat angle according the following steps (refer to the figure on
the next page):
* Front wheel:
1. Loosen the screws Ⓐ from the steering wheel adapter Ⓑ.
2. Choose correct size for the adapter Ⓑ and fork.
3. Place the steering wheel adapter in the desired position.
4. Tighten the screws Ⓐ properly.
5. Change diameter of the steering wheel if necessary
in.).

* Rear wheel:

6.
Remove the rear wheels (see § 2.13).
7. Loosen the fixing screws Ⓐ from the rear axle block Ⓑ.
8. Push the axle block Ⓑ upwards or downwards to the desired height.
9. Tighten the screws Ⓐ properly.
10. Mount the rear wheels.
11.
Adjust the brakes according § 3.8.
Rear wheel
Ø Holes
22" Hole 9 and 11
24" Hole 8 and 10
24" Hole 6 and 8
24" Hole 4 and 6
Table 3: Seat heights Eclips+
Page 17
Front wheel
Ø
Adapter Ⓑ /
fork
200 mm Short
140 mm Standard
200 mm Standard
200 mm Standard
(only for seat height 470 mm (18.5
Eclips+, Eclips+ 30°
2011-05
Holes
Hole 2 and 3
Hole 2 and 3
Hole 2 and 3
Hole 1 and 2