Adjusting Of The Tip Cap; Adjusting The Stability And The Maneuverability; Maintenance; Regular Maintenance - Vermeiren Eclips+ AD Mode D'emploi

EN

3.10 Adjusting of the tip cap

"
!
WARNING:
the appropriate tool.
A tip cap is mounted on the lower right back frame that can be adjusted in its height
depending on the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm (0.59 in.). (The
wheelchair with seat height 500 mm (19.69 in.) is the tip cap height adjustable in 150 mm
and 165 mm (5.91 in. and 6.50 in.)).
If an anti-tip device is installed, it replaces the addition of the tipping lever and can be used
accordingly.

3.11 Adjusting the stability and the maneuverability

"
!
WARNING:
the appropriate tool.
"
!
WARNING:
wheels on both sides are mounted in the same position.
"
!
WARNING:
wheelchair.
4

Maintenance

Lifetime of the wheelchair is influenced by its use, storage, regular maintenance, servicing
and cleaning.
4.1

Regular Maintenance

The maintenance activities to ensure a good condition for your Vermeiren wheelchair are
described below:
Before every ride
Risk of injury - Make sure that all screws are properly tightened with
Risk of injury - Make sure that all screws are properly tightened with
Risk of injury - Make sure that the axle adapters ! of the rear
Risk of tipping over - Be aware that you change the stability of the
& Check the tyres and make them clean. If necessary change the tire.
& Check screw fastenings are secured.
Check the brakes and adjusted if necessary.
&
& Check the wheelchair (cleanliness, cracks, damage on structural parts ... .)
and make it clean. If necessary change the coating.
1. Remove the screws !.
2. Adjust the height of the tip cap to a
comfortable position.
Tip cap height
150 mm (5.91 in.)
(Standard)
165 mm (6.50 in.)
Table 5: Tip cap heights for wheelchair with standard
seat height of 500 mm
3. Tighten the screws properly !.
The driving wheels are mounted in an axle adapter ! at
the bottom of the back frame ".
1. Loosen the fixing screws $.
2. Turn the axle adapter ! to the back until the axle
mounting is behind the back frame.
3. Tighten the screws properly $.
4. Adjust the brakes.
!"#$%''%
Eclips+ AD
Tube tip cap " Tube frame #
Hole 1 and 3 Hole 1 and 3
Hole 1 and 3 Hole 2 and 4
(Fig C)
2011-03