Installation And Adjustment; Tools; Manner Of Delivery; Adjusting The Seat Height And Seat Angle - Vermeiren V200 XL Mode D'emploi

3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren V200 XL has been designed to be adjust with a minimum of replacements
parts. There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING:
Risk of unsafe settings - Use only the settings described in this
   
manual.
WARNING:
Variation of allowed adjustments can still change the stability of your
   
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.
Wrench set n° 7 to n° 22
•
Allen keyset n° 3 to n° 8
•
Screwdriver n° 4 to n° 5
•
Screwdriver Phillips head
•
3.2

Manner of delivery

The Vermeiren V200 XL shall be delivered with:
1 frame with arm supports, rear and front wheels (standard delivery
•
seat height: 500 mm, seat angle: 5° )
•
1 footrest
•
Tools
•
Manual
•
Accessories
•
3.3

Adjusting the seat height and seat angle

The Vermeiren V200 XL is adjustable in 4 seat heights and 5 seat angles (0° -2,5° -5° -7,5° -
10° ) by changing the position of the wheels for each height and angle there is a different
setting of the front and rear wheels.
The summary of the different seat heights by a standard seat angle 5° is tabulated below.
Seat height
Hole Position axle plate
440 mm
f
470 mm
c
500 mm
e
(Standard)
530 mm
g
Rear wheels
Above
Under
Under
Under
Table 2: Seat heights by seat angle 5°
ƒ‰‡
Front wheels
Hole Bushing
relative to castor
stem housing
Above
c
Under
c
Under
d
Under
e
V200 XL
2012-02