Installation And Adjustment; Tools; Manner Of Delivery; Adjusting The Seat Height And Seat Angle - Vermeiren V300 DL Mode D'emploi

3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren V300DL has been designed to be adjust with a minimum of replacements
parts. There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L WARNING:
Variation of allowed adjustments can still change the stability of your
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.

Wrench set n° 10 to n° 22

Allen keyset n° 4 to n° 6
3.2

Manner of delivery

The Vermeiren V300DL shall be delivered with:

1 frame with armrests, rear and front wheels (standard delivery
seat height: 500 mm without seat cushion, seat angle: 5°)

Seat cushion

Anti-tipping (only right side)

1 pair footrests

Tools

Manual

Accessories
3.3

Adjusting the seat height and seat angle

The Vermeiren V300DL is adjustable in 4 seat heights and 5 seat angles (0°-2,5°-5°-7,5°-
10°) by changing the position of the wheels for each height and angle there is a different
setting of the front and rear wheels.
The summary of the different seat heights by a standard seat angle 5° is tabulated below.
Seat height
(without seat cushion)
440 mm
470 mm
500 mm (Standard)
530 mm

Rear wheels

Hole Hole
 
 
 
 
Table 2: Seat heights by seat angle 5°
Page 18
Front wheels
Ⓑ
Bushing relative to castor
stem housing
Above
Under
Under
Under
V300DL
2016-03
Ⓒ