Install The Dust Bag; Changing The Saw Blade; Cleaning; Disposal - HOLZMANN MASCHINEN TK305 Mode D'emploi

18.2 Install the dust bag

1. Squeeze the spring with your thumb and
forefinger.
2. Aligned dust hole, then insert it to the dust
hole annular groove; Release your fingers.

18.3 Changing the saw blade

 Never wear gloves during operation
Except for replacing saw blades or handling rough material before

operation.
1. Fix the mitre saw in the uppermost position
2. Loosen with the blade key the
fastening nut of the saw blade
3. Replace the saw blade
4. Attach the new blade again with the fastening nut

18.4 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as well
as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution!

18.5 Disposal

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or operating materials (like oil,...) in residual waste. If
necessary, contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
HOLZMANN MASCHINEN GmbH
C A U T I O N
N O T I C E
www.holzmann-maschinen.at
MAINTENANCE
41
TK 305