Starting The Machine; Stopping Machine; Saw Blade Height Adjustment; Adjustment Of The Saw Blade Tilt - HOLZMANN MASCHINEN TS315F1600 Mode D'emploi

15 OPERATION
15.1 Initial check before start
 Check that the max. speed of the machine is lower than the max. permissible
speed of the used saw blade.
 Use only sawblades with a diameter of 315mm.
 Make sure that the inner diameter of the saw blade corresponds to the diameter
of the drive shaft.
 The saw blade guard must be mounted on the riving knife. Working with the
machine without saw blade protection guard is prohibited.
 Ensure connection to a dust collection system (A).
15.2 Operation

15.2.1 Starting the machine

Green ON-button (I): start the machine
Red OFF-button (0): stop the machine

15.2.2 Stopping machine

Normal stop:
Press the OFF-button (0). The saw blade stops its movement.
Only in emergency situations:
Stopping the machine using one of the two EMERGENCY-STOP button.
To pull out the EMERGENCY-STOP button, turn to the left and tighten it slightly if
necessary.

15.2.3 Saw blade height adjustment

15.2.4 Adjustment of the saw blade tilt

After adjusting the saw blade tilt, adapt the rip fence and/or the cross-cut fence so
that they do not become contact with the tilted saw blade.

15.2.5 Adjustment of the cutting width

HOLZMANN MASCHINEN GmbH
NOTICE
www.holzmann-maschinen.at
The handwheel for height adjustment is located
laterally on the machine. Loosen the fixing
screw on the handwheel in order to move the
saw blade. Turn the handwheel clockwise to lift
the saw upwards. Turn the handwheel anti-
clockwise to lift the saw downwards. The height
of the saw blade must be adjusted so that the
teeth hit the top of the workpiece.
The saw blade can tilt from 0° to 45°. Turn the
handwheel clockwise to tilt the saw blade. Turn
the handwheel anticlockwise to move the saw
blade in a vertical position again. The current
position can be seen on the scale.
The cutting width can be adjusted on the rip
fence so that it can be read off the ruler. The rip
fence can be fixed by tightening the star screws.
OPERATION
46
TS315F1600