Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Start-up and operation
Teach-in
WARNING
Risk of crushing due to unintentional start-up of the RollerDrive!
Changes in this menu have direct influence on the connected RollerDrive!
¾
Before starting motors make sure, ensure that no persons are present in the hazardous areas surrounding
¾
the conveyor system!
Teach-in Feature
Please read the manual before trigger any of the options below!
Init
Start
Finish
Abort
Submit
Reset
Plug&Play
Plug and Play Feature
Enabled
Submit
The "Teach-in" and "Plug&Play" functions are described in the "MultiControl / RollerDrive - Start-up and
Programming" supplement.
CAN Gateway
CAN Bus Terminal
Mode
Node ID
SDO Idx
Read
dec num
hex num
Write
Send
Node 0>> Response: Unknown, Error: 0
Only used for service purposes.
48 of 140
CAN Gateway
Sub Idx
Length
Data
hex num
dec num
hexabytes, e.g. 0FF640
Teach-in
Plug&Play
Translation of the original operating manual
Version 2.7 (05/2021) UL
Publicité
Chapitres
Table des Matières
