Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly and installation
Subsequent assembly
If a MultiControl that has already been connected needs to be detached from the base plate, the ribbon cables must
not make contact again at the same point, as otherwise proper contact cannot be guaranteed. So as not to have
to disconnect the ribbon cables from all MultiControls and then reconnect them, in this case the MultiControl can be
attached via the installation holes on the right.
Version 2.7 (05/2021) UL
24 of 140
Translation of the original operating manual
Publicité
Chapitres
Table des Matières
