Multicontrol User Interface; Prerequisites; Starting The User Interface - Interroll MultiControl AI Notice D'utilisation

Start-up and operation
6.3

MultiControl user interface

The MultiControl has an integrated web server that generates a user interface for configuring the MultiControl. This
user interface can be opened on a computer connected to the MultiControl.
Except for a web browser, no further software needs to be installed on the computer.

Prerequisites

The following prerequisites must be fulfilled in order to start the web-based user interface:
• The MultiControl has a valid IP address that is known (default setting: IP address 192.168.0.1, subnet mask
255.255.255.0).
• The connected computer must be in the same IP range (see system description/network settings for the PC).
• There is an Ethernet connection between the MultiControl and the computer.
• Port 80 can be accessed (user interface is HTTP-based).
• The MultiControl is not configured for EtherCAT, as EtherCAT does not permit HTTP communication. The bus
type can be read using the magnetic sensor (see the "MultiControl / RollerDrive - Start-up and Programming"
supplement).

Starting the user interface

Start the web browser on the computer connected to the MultiControl.
¾
In the address line, enter the IP address of the MultiControl (default setting: http://192.168.0.1/).
¾
On the login page, enter the login data (default setting: User name "Interroll", password "Interroll").
¾
Unless otherwise specified, the figures apply to the MultiControl AI and the MultiControl BI.
32 of 140
Version 2.7 (05/2021) UL
Translation of the original operating manual