Warning Notices For Electrical Installation - Interroll MultiControl AI Notice D'utilisation

5.3

Warning notices for electrical installation

CAUTION
Risk of injury when working on electrical equipment.
Electrical installation work must only be carried out by a qualified electrician.
¾
Before installing, removing or connecting the MultiControl, switch off the power to the conveyor system and
¾
ensure that it cannot be unintentionally switched on again.
Set all the power supplies used to the same earth potential in order to avoid compensating currents via the
¾
MultiControl or bus cable.
Ensure all components are earthed correctly. Improper earthing can lead to a build-up of static charge,
¾
which can result in a fault or premature failure of the MultiControl.
Ensure that suitable switching devices and protective systems are in place that will allow the equipment to be
¾
operated safely.
Only switch on the operating voltages when all cables are connected.
¾
NOTE
Improper electrical installation can result in damage to the MultiControl.
Observe national regulations for electrical installation.
¾
Only operate the MultiControl with a protective extra-low voltage (PELV) of 24 V or 48 V.
¾
Never operate the MultiControl with an alternating voltage.
¾
Ensure that the polarity of the power supply is correct.
¾
Ensure that the existing electrical installation has no disruptive influence on the MultiControl.
¾
Only use cables that are adequately dimensioned for the specific operating conditions.
¾
Ensure that the calculations for the drop in voltage in the cables are taken into account.
¾
Observe regulations for laying cables.
¾
Do not expose the connectors to excessively high tensile or pressure loads. If the connector cable is bent, this
¾
can damage the cable insulation and cause the MultiControl to fail.
Version 2.7 (05/2021) UL
Translation of the original operating manual
Assembly and installation
25 of 140