Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety-related information
2.5
Dangers
Here, you will find information about the different types of dangers or damage that can occur in
connection with the operation of the MultiControl.
Injury to persons
¾ Maintenance, installation and repair work on the unit must only be carried out by authorised technical personnel
in compliance with the applicable provisions.
¾ Before switching on the MultiControl, ensure that no unauthorised personnel are situated in the vicinity of the
conveyor/conveying system.
Electricity
¾ Installation and repair work must only be carried out when the system has been disconnected from the power
supply. Switch off the power to the MultiControl and ensure that it cannot be unintentionally switched on again.
Work environment
¾ Remove any materials and objects that are not required from the working area.
Faults in operation
¾ Regularly check the MultiControl for visible damage.
¾ If smoke develops, immediately switch off the power to the MultiControl and ensure that it cannot be
unintentionally switched on again.
¾ Immediately contact specialist personnel to determine the cause of the malfunction.
Maintenance
¾ Since the product in question requires no maintenance, it is sufficient to simply examine the MultiControl for
visible damage on a regular basis.
¾ Never open up the MultiControl.
Unintentional start-up
¾ Ensure that the connected RollerDrives/motors cannot start up unintentionally, particularly during assembly and
maintenance work or in the event of a fault.
12 of 140
Version 2.7 (05/2021) UL
Translation of the original operating manual
Publicité
Chapitres
Table des Matières
