Initial Operation - Migatronic MIG 300 STB Manuel D'instruction

Mains connection
The machine must be connected to a three-phase
mains supply and it is important to ensure that the
mains supply voltage is in accordance with the voltage
to which the machine is built.
Configuration
MIGATRONIC disclaims all responsibility for damaged
cables and other damages related to welding with
under sized welding torch and welding cables
measured by welding specifications e.g. in relation to
permissible load.
It must be ensured that the air inlet and outlet are not
blocked.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee
Warning
Connection to generators can damage the welding
machine.
When connected to a welding machine, generators
can produce large voltage pulses, which can damage
the welding machine. Use only frequency and voltage
stable generators of the asynchronous type.
Defects on the welding machine arising due to
connection of a generator are not included in the
guarantee.
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth
cables and intermediary cables to
the machine.

INITIAL OPERATION

How to connect the separate wire feed unit
The machine is always delivered with a MWF 8 wire
feed unit.
The plug kit for the MWF 11/21 wire feed units can
be mounted according the mounting instructions
which can be found together with the plug kit
8