Husqvarna 120 Mark II Manuel D'utilisation page 25

correct depth gauge setting for your
particular chain.
Note:
This recommendation assumes that
the length of the cutting teeth is not
reduced excessively.
Use a flat file and depth gauge tool to
adjust the depth gauge.
1. Put the depth gauge tool above the saw
chain. Detailed information regarding
how to use the depth gauge tool will be
found on the package of the depth
gauge tool.
2. Use the flat file to file off the tip of the
depth gauge that protrudes through the
depth gauge tool. The depth gauge
setting is correct when you no longer
feel resistance as you draw the file
along the depth gauge tool.
To tension the saw chain
Note:
Check the tension of a new saw
chain frequently during its running-in
period.
654 - 006 - 10.02.2020
A
B
1. Loosen the guide bar nuts that hold the
clutch cover. Use the combination
wrench.
C
2. Tighten the guide bar nuts by hand as
tight as you can.
3. Lift the top of the guide bar and extend
the saw chain by tightening the chain
tensioning screw. Use the combination
wrench. Tighten the saw chain until it
does not hang down from the bottom of
the guide bar.
25