Husqvarna 120 Mark II Manuel D'utilisation page 10

To examine the throttle trigger lockout
1. Make sure that the trigger (B) is locked
at idle when you release the trigger
lockout (A).
A
B
2. Push the trigger lockout (A) and make
sure that it goes back to its initial
position when you release it.
3. Push the trigger (B) and make sure that
it goes back to its initial position when
you release it.
4. Start the engine, and then apply full
speed.
5. Release the trigger and examine if the
saw chain stops.
6. If the saw chain turns with an idle
engine, examine the idle adjustment
screw of the carburetor.
Guard
The guard prevents objects from being
ejected in the direction of the operator. The
guard also prevents accidental touch
between the operator and the saw chain.
• Make sure that the guard is permitted
for operation in combination with the
product.
• Do not use the product without the
guard.
• Make sure that the guard is not
damaged. Replace the guard if it is worn
or has cracks.
Fuel safety
• Do not start the product if there is fuel or
engine oil on the product. Remove the
unwanted fuel/oil and let the product
10
dry. Remove unwanted fuel from the
product.
• If you spill fuel on your clothing, change
clothing immediately.
• Do not get fuel on your body, it can
cause injury. If you get fuel on your
body, use a soap and water to remove
the fuel.
• Do not start the engine if you spill oil or
fuel on the product or on your body.
• Do not start the product if the engine
has a leak. Examine the engine for
leaks regularly.
• Be careful with fuel. Fuel is flammable
and the fumes are explosive and can
cause injuries or death.
• Do not breathe in the fuel fumes, it can
cause injury. Make sure that there is a
sufficient airflow.
• Do not smoke near the fuel or the
engine.
• Do not put warm objects near the fuel or
the engine.
• Do not add the fuel when the engine is
on.
• Make sure that the engine is cool before
you refuel.
• Before you refuel, open the fuel tank
cap slowly and release the pressure
carefully.
• Do not add fuel to the engine in an
indoor area. Not sufficient airflow can
cause injury or death because of
asphyxiation or carbon monoxide.
• Tighten the fuel tank cap carefully or a
fire can occur.
• Move the product at a minimum of 3 m
(10 ft) from the position where you filled
the tank before a start.
• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur
when you move the product or fuel
container.
• Do not put the product or a fuel
container where there is an open flame,
spark or pilot light. Make sure that the
storage area does not contain an open
flame.
654 - 006 - 10.02.2020