Husqvarna 120 Mark II Manuel D'utilisation page 24

• Cutting angle.
• File position.
• Round file diameter.
To sharpen the cutting teeth
Use a round file and a file gauge to
sharpen the cutting teeth. See
filing and saw chain combinations on page
29 for information on the recommended
dimension of the file and gauge for the saw
chain installed on your product.
24
1. Make sure that the saw chain is
2. File all teeth on one side first. File the
A
3. Turn the product over and file the teeth
4. File all the teeth to the same length.
To adjust the depth gauge setting
Sharpen the cutting teeth before you adjust
the depth gauge setting. See
the cutting teeth on page 24 . When you
Ø
sharpen the cutting tooth (A), the depth
gauge setting (C) will decrease. To
maintain optimal cutting performance, the
depth gauge (B) has to be filed down to
achieve the recommended depth gauge
setting. See
combinations on page 29 to find the
Saw chain
correctly tensioned. A slack chain will
move sideways, making it more difficult
to sharpen correctly.
cutting teeth from the inside face and
reduce the pressure on the return
stroke.
on the other side.
When the length of the cutting teeth is
reduced to 4 mm (5/32") the saw chain
is worn out and must be replaced.
A
Saw chain filing and saw chain
654 - 006 - 10.02.2020
To sharpen