Husqvarna 120 Mark II Manuel D'utilisation page 15

CAUTION:
gasoline with an octane
number less than 90 RON (87
AKI). This can cause damage
to the product.
Note:
Use gasoline with a higher
octane number if you frequently use the
product at continuously high engine
speed.
3. Add the full quantity of the two-cycle
engine oil to the fuel container.
CAUTION:
cooled two-cycled engine oil of
high quality. Other oils can
cause damage to the product.
4. Shake the fuel mixture to mix the
contents.
5. Add the remaining gasoline quantity to
the fuel container.
6. Shake the fuel mixture to mix the
contents.
7. Fill the fuel tank of the product with the
fuel mixture. See
14 .
To fill the fuel tank
1. Make sure that the fuel mixture is
correct and that the fuel mixture is in a
fuel container with an antispill valve.
2. If fuel is on the container, remove the
unwanted fuel and let the container dry.
3. Make sure that the area near the fuel
tank cap is clean.
4. Remove the fuel tank cap.
5. Shake the fuel container before you add
the fuel mixture to the fuel tank.
6. Put back the fuel tank cap.
To lubricate the saw chain
The product has an automatic lubrication
system. The saw chain oil tank and the fuel
tank are designed so that the fuel runs out
before the saw chain oil. This safety feature
requires that the correct chain oil is used
and that the instructions are obeyed.
654 - 006 - 10.02.2020
Do not use
Always use air-
To use fuel on page
1. Use vegetable-based saw chain oil or a
standard chain oil.
2. Make sure that the area near the cap of
the saw chain oil tank is clean.
3. Remove the cap of the saw chain oil
tank.
4. Fill the saw chain oil tank with the
recommended saw chain oil.
5. Put back the cap of the saw chain oil
tank.
To start and stop
Before you start the engine
• Examine the product for missing,
damaged, loose or worn parts.
• Examine the nuts, screws and bolts.
• Examine the air filter.
• Examine the trigger lockout and the
trigger for correct operation.
• Examine the stop switch for correct
operation.
• Examine the product for fuel leaks.
• Examine the saw chain sharpness and
tension.
To start a cold engine
1. Move the front hand guard forward to
engage the chain brake.
15