Husqvarna 120 Mark II Manuel D'utilisation page 16

2. Pull the choke control out fully.
3. Push the air purge bulb 6 times.
4. Hold the body of the product on the
ground with your left hand.
5. Put your right foot through the rear
handle.
6. Pull the starter rope handle slowly with
your right hand until you feel some
resistance.
16
7. Pull the starter rope handle with force.
CAUTION:
starter rope until it stops. Do
not let go of the starter rope
when it is fully extended.
Release the starter rope
slowly. If you do not obey
these instructions, it can
cause damage to the engine.
Note:
Do not pull the throttle trigger
when you start the engine.
8. Continue to pull the starter rope handle
until the engine starts or tries to start
(pull max 5 times).
9. If the engine starts or tries to start, push
the choke control in to the half choke
position.
10.Continue to pull until the engine starts.
Do not pull the
654 - 006 - 10.02.2020