Maintenance; Maintenance Schedule; Daily Maintenance - Husqvarna 120 Mark II Manuel D'utilisation

• If the log is supported on both ends, cut
1/3 the diameter from the top. Complete
the cut by underbucking the lower 2/3 of
the log to meet the first cut.
WARNING:
understand the safety chapter
before you clean, repair or do
maintenance on the product.

Maintenance schedule

Make sure that you obey the maintenance
schedule. The intervals are calculated from
daily use of the product. The intervals are
different if you do not use the product each
day. Only do the maintenance work that is
found in this manual. Speak to an approved
service center about other maintenance
work not found in this manual.

Daily maintenance

• Clean the external surfaces.
• Make sure that the lockout and trigger
work correctly.
20

Maintenance

Read and
• If you buck a log on a slope, always
stand on the uphill side of the log. Cut
through the log while you maintain
complete control of the product, then
release the cutting pressure near the
end of the cut while firmly gripping the
rear handle and front handle.
• Clean the chain brake and make sure
that it works correctly.
654 - 006 - 10.02.2020