Husqvarna 120 Mark II Manuel D'utilisation page 18

Note:
Always use new fuel and decrease
the operation time during warm weather.
1. Put the product in a cool area away from
open sunlight.
2. Let the product cool down for 20
minutes at minimum.
3. Press the air purge bulb again and
again for 10-15 seconds.
4. Obey the procedure to start a cold
engine. Refer to
on page 15 .
To stop the engine
• Push the stop switch to stop the engine.
Note:
The stop switch automatically goes
back to its initial position.
To fell a tree
1. Remove dirt, stones, loose bark, nails,
staples and wire from the tree.
2. Make a notch 1/3 the diameter of the
tree, perpendicular to the direction of the
fall.
3. Make the lower horizontal notch cut.
This will prevent either the saw chain or
the guide bar from being pinched when
the second notch is made.
18
To start a cold engine
4. Make the felling back cut (X) at least 50
mm (2 in) higher than the horizontal
notching cut. Keep the felling back cut
parallel to the horizontal notching cut so
enough wood is left to act as a hinge.
Do not cut through the hinge. The hinge
wood keeps the tree from twisting and
falling in the wrong direction.
X
Y
654 - 006 - 10.02.2020