Husqvarna 120 Mark II Manuel D'utilisation page 12

2. Remove the bar nuts and the sprocket
cover. Remove the transportation guard
(A).
3. Put the guide bar above the bar bolts.
Steer the guide bar to its most rear
position.
4. Put on protective chainsaw gloves.
12
5. Lift the saw chain above the drive
sprocket and engage it in the groove on
the guide bar. Start on the top edge of
the guide bar.
A
6. Make sure that the edges of the cutting
links are turned forward on the top edge
of the guide bar.
7. Assemble the sprocket cover and steer
the chain adjuster pin to the hole in the
guide bar.
8. Make sure that the drive links of the saw
chain fit correctly on the drive sprocket.
Also make sure that the saw chain is
correctly engaged in the groove in the
guide bar.
9. Tighten the guide bar nuts with your
fingers.
654 - 006 - 10.02.2020