Husqvarna 120 Mark II Manuel D'utilisation page 13

10.Tighten the saw chain by turning the
chain tensioning screw clockwise with
the combination wrench
. Tighten the saw chain until it does not
sag from below the guide bar, but you
can turn it easily by hand.
654 - 006 - 10.02.2020
11.Hold up the end of the guide bar and
tighten the bar nuts with the combination
wrench.
• Examine the chain tension frequently
after you assemble a new saw chain
and until the saw chain has been run-
in.
• Examine the chain tension regularly.
Correct chain tension results in good
cutting performance and a long life.
To reset the chain brake
If the clutch cover is removed accidentally
while the chain brake is locked, the chain
brake must be unlocked so the clutch cover
can be assembled without binding to the
clutch drum.
CAUTION:
spring is under tension. Use care
when resetting the chain brake.
Note:
Do not hold the brake band while
attempting to reset it.
The chain brake
13