Removing The Charger; Maintenance And Care; Maintenance; Care - APA 16619 Manuel De L'opérateur

Masquer les pouces Voir aussi pour 16619:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Error messages
Display of error after faulty connection (wrong poles), short-circuit, selection of an incorrect
charging programme or overheating.
Error message in 6 V – mode, if a battery is connected with less than 5.5 V ± 0.2 or the
voltage is still lower than 6 V after 4 hours of charging time.
In this case, the battery is defective and must be replaced.

6.6 REMOVING THE CHARGER

CAUTION
First pull the plug out of the socket and observe
the sequence for disconnection. This prevents
sparks from forming. Since charging generates
a detonating gas, this is particularly important
for the sake of your safety.
Disconnect the charger from the mains power supply.
Separate the adapter connection of the charging cable.
Disconnect the pole callipers from the battery, fi rst minus
then plus.
Allow the battery to cool down.
Only for open batteries: Fill the cells with distilled water
up to the level specifi ed by the battery manufacturer. Close
the battery cells with the stoppers.

7. MAINTENANCE AND CARE

7.1 MAINTENANCE

If used correctly, the device is maintenance-free.

7.2 CARE

Clean the pole callipers every time the charging procedure
is completed. Remove all splashed battery acid from the
pole callipers to prevent corrosion. Clean the device careful-
ly with a dry cloth. Do not use liquids or chemical cleaning
agents. Never submerge the device in liquids. Never allow
liquid to fl ow over the device.
Before storing the device, roll up the cables properly using
the designated hook in order to prevent damages to the
cables and device. Store the device in a clean and dry place.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

The packaging is made up of environmentally
friendly materials which may be disposed of via
your local recycling points.
Do not put electrical devices into the house-
hold waste. Electronic and electrical devices
must be collected separately and sent for en-
vironmentally friendly recycling. Contact your
community or town administration for
information regarding the disposal of electrics.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
11

Publicité

Table des Matières
loading

Table des Matières