Removing The Charger; Maintenance And Care; Maintenance; Care - APA 16622 Manuel De L'opérateur

6.6 REMOVING THE CHARGER

Caution: First pull the plug out of the socket and observe the sequence for disconnection. This prevents sparks from
forming. Since charging generates a detonating gas, this is particularly important for the sake of your safety.
Disconnect the charger from the mains power supply. Separate the adapter connection of the charging cable.
First disconnect the pole callipers from the battery, fi rst minus then plus. Allow the battery to cool down.
Only for open batteries: Fill the cells with distilled water up to the level specifi ed by the battery manufacturer. Close the battery
cells with the stoppers.

7. MAINTENANCE AND CARE

7.1 MAINTENANCE

If used correctly, the device is maintenance-free.

7.2 CARE

Clean the pole callipers every time the charging procedure is completed. Remove all splashed battery acid from the pole callipers to
prevent corrosion. Clean the device carefully with a dry cloth. Do not use liquids or chemical cleaning agents. Never submerge the
device in liquids. Never allow liquid to fl ow over the device.
Before storing the device, roll up the cables properly using the designated hook in order to prevent damages to the cables and
device. Store the device in a clean and dry place.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

The packaging is made up of environmentally friendly materials which may be disposed of via your local recy-
cling points. Do not put electrical devices into the household waste. Electronic and electrical devices must be
collected separately and sent for environmentally friendly recycling. Contact your community or town administrati-
on for information regarding the disposal of electrics.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
13