Selecting The Charging Mode; Removing The Charger; Maintenance And Care; Maintenance - APA 16629 Manuel De L'opérateur

6.5.2 SELECTING THE CHARGING MODE

If only a small battery is to be charged or normal charging is
suffi cient, set the switch for charging mode (Position 2 in the
overview) to the „NORMAL" setting. For large batteries, or if
fast charging is required, set the switch to „FAST".
Now connect the mains connection cable (Position 10 in the
overview) of the battery charger to the power socket. Now
the green control lamp „ON" (Position 6 in the overview)
and the yellow control lamp „CHARGING" (Position 5 in the
overview) light up. The battery is being charged.
Once the battery is fully charged, the battery charger switches
over to maintenance mode. The green „FULL" control lamp
(Position 4 in the overview) lights up.

6.6 REMOVING THE CHARGER

CAUTION
First pull the plug out of the socket and observe
the sequence for disconnection. This prevents
sparks from forming. Since charging generates a
detonating gas, this is particularly important for
the sake of your safety.
Disconnect the charger from the mains power supply.
Then disconnect the black callipers (minus). Then remove
the battery callipers from the plus pole of the battery (red
callipers).
Allow the battery to cool down.
Only for open batteries: Fill the cells with distilled water
up to the level specifi ed by the battery manufacturer. Close
the battery cells with the stoppers.

7. MAINTENANCE AND CARE

7.1 MAINTENANCE

The battery charger is maintenance-free when used in
accordance with the intended purpose.

7.2 CARE

Clean the pole callipers every time the charging procedure
is completed. Remove all splashed battery acid from the
pole callipers to prevent corrosion. Clean the device careful-
ly with a dry cloth. Do not use liquids or chemical cleaning
agents. Never submerge the device in liquid. Never allow
liquid to fl ow over the device.
Properly roll up the cable onto the holders supplied before
storing the device in order to prevent damage to the cables
and the device. Store the device in a dry and clean location.
10

8. NOTES REGARDING ENVIRONMENTAL

PROTECTION

The packaging is made up of environmentally
friendly materials which may be disposed of via
your local recycling points. Do not put electrical
devices into the household waste. Electronic
and electrical devices must be collected sepa-
rately and sent for environmentally friendly
recycling. Contact your community or town
administration for information regarding the
disposal of electrics.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com