Selecting The Display; Selecting The Charging Mode/Jump Start; Removing The Battery Charger; Jump Start - APA 16631 Manuel De L'opérateur

battery type. The diff erent battery types are toggled through in the following order: 6 V STD – 12 V STD – 12 V
AGM – 12 V Gel.

6.4.2 Selecting the display

Use the selection switch for the display (Position 3 in the overview) to toggle the display from the current battery
voltage to the charge status in % (5% increments).

6.4.3 Selecting the charging mode/jump start

Use the selection switch for the charging mode (Position 4 in the overview) to choose between the functions SLOW
(charge slowly), FAST (charge quickly) and START (jump start).
Once the battery is fully charged the display shows FUL (current battery voltage) or 100 in %.

6.5 Removing the battery charger

Caution: First pull the plug out of the socket and observe the sequence for disconnection. This prevents
sparks from forming. Since charging generates a detonating gas, this is particularly important for the
sake of your safety.
Disconnect the charger from the mains power supply.
Then disconnect the black clips (negative). Then remove the battery clips from the positive terminal of the battery (red clips).
Allow the battery to cool down. Only for open batteries: Fill the cells with distilled water up to the level specifi ed by
the battery manufacturer. Close the battery cells using the caps.

6.6 Jump start

Before performing a jump start on your vehicle, read how to carry out a jump start in your vehicle's manual.
Switch off all electrical consumers in the vehicle (lights, window heater, seat heating, etc.). Connect the device to
the vehicle battery as described in section 6.3. Use the selection switch to choose the 12 V battery type appropriate
for your vehicle. Position the selection switch for charging mode/jump start to START.
Now start the vehicle's engine. Do not operate the starter for longer than 5 seconds. If the start attempt is not
successful, wait for at least three minutes before starting the next attempt. After the third failed attempt, do not
attempt again. Instead, check your vehicle for faults.
Once the engine is running, remove the device as described in section 6.5.

7. Troubleshooting

Error
Display
10
Possible cause
No contact to battery.
Positive (+) and negative (-) terminal
clips reversed on the battery.
Short circuit, the terminal clips are
touching or there is a connection bet-
ween the battery terminals.
Measure
Check the cable connection and connect
correctly.
Remove the terminal clips from the
battery and connect them correctly.
Remove the terminal clips from the battery
and connect them correctly.
Check for a metallic object causing the short
circuit between the battery terminals or
between the ground strap and the positive
terminal.